Dla LH2.4 wygląda to tak:erni35 pisze:Na "migadełku" wyświetliło mi błąd 212 i 213. Co to na chłopski rozum oznacza?
2-1-2
2-1-3Condition
If the signal is missing the control module cannot manage the fuel trim processes. A diagnostic trouble code (DTC) is stored if the signal is ncorrect (above 1.1 V) or missing (0.5 V) 3 minutes after the temperature has exceeded 80 °C.
Possible source
-Open–circuit, short-circuit to supply voltage in cables to heated oxygen sensor (HO2S).
-Contact resistance in terminals.
-No preheating to heated oxygen sensor (HO2S)
Fault symptom[s]
High fuel consumption, can give driveability problems.
Condition
The throttle position (TP) switch indicates full load but the control module's information on the load signal is that it is too low to be fully loaded. The diagnostic trouble code (DTC) will be stored if the engine is not about to start or in an emergency program.
Possible source
Short–circuit to ground in cable to control
module. Full load switch does not break.
Fault symptom[s]
Nomally no fault symptom.